8’ High basement poured concrete walls strapped with 2”x 4” ’s and insulated to code.

Steel beams and posts where applicable.

2”x6” exterior walls on 16" centers.

Silent Floor Joists to code, with ¾” tongue and groove OSB board glued and power nailed.

All above grade exterior windows to be high efficiency, Low-E Argon. Casement type except for vinyl sliders in basement.

All exterior doors to be insulated steel clad.

Exterior walls -R-22 insulation. Ceilings –R50, and basement R-20 15” above basement floor grade.

Aluminum fascia, soffit, eaves trough, and downspouts.

25 Year shingles with an engineered truss roof.

7/16" OSB wafer board roof sheathing.

Brick front with Vinyl siding on remainder of exterior walls.

Patio slab walkway from garage/driveway to front entrance.

7 meter wide gravel driveway

Lot to be sodded from front of house to street with remainder of lot to be machine graded.

All exterior doors and windows and applicable areas to be weather caulked.

Garage doors to be baked enamel steel insulated sectional doors.

Two exterior water taps to be installed; one at the front and one at the rear.

Exterior weatherproof electrical outlet to be installed; one at the front and one at the rear.

All walls and ceilings to be ½” drywall and stippled ceilings throughout except kitchen and baths.

Furniture finish kitchen cupboards and bathroom vanities with counter tops and mirror over vanity sinks only. ($20,000 Dollar allowance for kitchen and vanities)

All interior doors to be 800 series and colonial trim throughout.

All interior walls and trim to be primed and to receive one coat of finish paint.

Exterior and interior door hardware to be brushed nickel ball type.

All above ground stairs are to be carpet grade and have oak spindles and handrails.

200 amp electrical service with breaker panel and copper wiring throughout and heavy-duty receptacle outlet for stove and dryer. 3 Telephone and 2 Television outlet rough-in supplied.

Ductless fan-hood, electrical door chime, smoke and carbon monoxide detectors as per code.

Dryer vent to be installed to exterior.

All interior and exterior light fixtures to be supplied and installed.

Electrical plug and lights to be installed in garage including garage door operator as per Code.

Central vacuum piping to be roughed in to basement.

Kitchen sink to be doubled stainless steel and all water piping to be plastic.

All taps (excluding laundry and exterior) to be Moen Type.

Plastic laundry tub to be installed with automatic washer drain. Tub and shower units to be one piece.

Gas hot water tank installed. (Rental)

Hi-Efficiency gas furnace to be installed with HRV unit according to building code.

3 Pc bathroom roughed-in in basement.

Entranceway, foyer, kitchen, and bathroom floors to be ceramic tile.

Carpet to be 40 oz with under pad through the remainder of house.

House to be professionally cleaned before occupancy.